G G
www.forsmw.com
23
Mechanical pendulum bogie jacking points (bogie block must be installed)
• Check the wheel nuts. Insure that wheel nuts are in place and that they are tightened according
to the chapter on Tightening torque;
• Check the air pressure in the tires. Please note that high temperature could raise tire pressure
and reduce load or speed required. In that case do not release air out from tires because tires will
get underinated after temperature returns to normal. Over ination could cause burst of tire.
• For suitable wheel sizes and air pressure see chapter for Technical information.
• Tires must be disposed at authorized location.
Do not exceed trailers maximum design speed or maximum load. Avoid holes, sudden manoeuvres or
high speeds when turning.
Maintenance undercarriage
Every day -It is necessary to visually check the nuts on the undercarriage each time the customer
uses the trailer. If the axel for the bogie side is at all moving the trailer is in
DANGER. Stop at once and
tighten the bolts as shown in pictures below.
BIGAB tandem parabolic bolts tightening BIGAB sprung pendulum bolts tightening
To Next Page
Loading...
