Need help?Do you have a question about the BIGTREETECH OCTOPUS - PRO and is the answer not in the manual?
General| Core | ARM Cortex-M7 |
|---|---|
| USB Interface | USB 2.0 |
| Driver Support | TMC5160, TMC2209 |
| Communication Interface | UART, SPI, I2C, CAN |
| Firmware | Marlin, Klipper |
| Power Input | 12V-24V |
| ADC Channels | 16 |
| DAC Channels | 2 |
| Dimensions | 100mm |
| Endstop Input | 8x |
| UART Ports | 8x |
Details the key features of the Octopus-pro V1.0 motherboard, including processor, firmware support, and voltage selection.
Lists the physical and electrical specifications of the Octopus-pro motherboard, such as size, voltage ranges, and supported interfaces.
Explains how to connect power supplies to the motherboard, including motor, bed, and logic power inputs and polarity.
Describes the wiring procedure for the BIGTREETECH Relay V1.2 module for automatic power down functionality.
Illustrates how to correctly wire a BL Touch sensor to the motherboard for automatic bed leveling.
Details the connection process for the BIGTREETECH mini UPS for power loss recovery.
Provides instructions on connecting RGB LEDs to the motherboard, referencing silkscreen for pinout details.
Explains methods for connecting a Raspberry Pi for printing, via USB-C, UART, or SPI.
Guides users on connecting bed probes to the dedicated port, including jumper settings for NPN/PNP probes.
Explains how to configure stepper drivers using Step/Dir mode and setting jumpers for microstepping.
Details the jumper configuration for operating stepper drivers in UART mode.
Shows the jumper settings required to operate stepper drivers in SPI mode.
Describes how to configure motor driver voltage using jumpers, allowing selection between motherboard and motor input voltage.
Explains how to set the voltage for fan outputs and proximity sensor input using jumpers (24V, 12V, 5V).
Details the 'diag' jumpers for enabling StallGuard feature on TMC drivers, connecting diagnostic pins to endstop inputs.
Explains the MCU power jumper for powering the board via USB-C, facilitating DFU mode firmware updates.
Covers the configuration of DIP switches for PT100/PT1000 amplifier connections (2, 3, or 4 wire).
Provides the physical dimensions of the Octopus-pro motherboard, including edge-to-edge and mounting hole sizes.
Illustrates the location and labels of various connectors on the Octopus-pro motherboard.
Offers a snippet of the motherboard pinout diagram, advising to consult the PINS.pdf for full details.
Provides tables for common stepper driver jumper settings and microstepping configurations for convenience.
To Next Page
