Why is my Binder KMF-240-UL Laboratory Equipment chamber not heating up?
If your Binder Laboratory Equipment chamber isn’t heating up, it could be due to a defective Pt 100 sensor, in which case you should contact BINDER service. It could also be due to a defective heating element or a defective semiconductor relay.
How to fix a Binder KMF-240-UL Laboratory Equipment chamber that is heating permanently?
If the chamber of your Binder Laboratory Equipment is heating permanently and the set-point is not maintained, it could be due to a defective controller, in which case you should contact BINDER service. Alternatively, the controller might not be well adjusted, or the adjustment interval may have been exceeded. In this case, calibrate and adjust the controller.
Why am I getting wrong temperature alarms on my Binder KMF-240-UL Laboratory Equipment?
If you experience wrong temperature alarms or disturbance of temperature accuracy with your Binder Laboratory Equipment, it may be because the temperature unit has been changed to °F. Set the temperature unit back to °C.
General safety rules for installation and operation.
Defines the proper applications and limitations of the unit.
Instructions for safely moving and transporting the unit.
Requirements for the installation site and environmental conditions.
Instructions for connecting the unit to the power supply.
Explains the different operating modes (Idle, Manual, Program).
Steps to input temperature and humidity set points.
How to create programs using the controller menu.
Details entering temperature and fan speed into program tables.
Details entering humidity values into program tables.
Explains ramp vs. step programming methods.
Examples of entering ramp and step program types.
Tips and rules for programming transitions.
Describes the primary over-temperature protection.
Explains the secondary safety controller for over-temperature.
Defines 'Limit' and 'Offset' types for the safety controller.
Guides on checking and configuring the safety controller.
Details the optional combined safety device class 3.3.
Instructions for setting and checking the class 3.1 safety device.
Instructions for setting and checking the class 3.2 safety device.
Overview of the unit's notification and alarm system.
Procedures for acknowledging and clearing alarms.
Explains how the humidification and dehumidification systems work.
Recommended schedules for maintenance and service.
Procedures for cleaning and decontaminating the unit.
Detailed steps for cleaning internal and external surfaces.
Procedures for decontaminating hazardous material contamination.
Solutions for problems related to chamber heating functions.
Troubleshooting for low or no refrigeration.
Addresses issues with the MB1 controller display and functions.
General| Model | KMF-240-UL |
|---|---|
| Category | Laboratory Equipment |
| Type | Constant Climate Chamber |
| Temperature Range | -10 °C to 100 °C |
| Volume | 240 liters |
| Power Supply | 230 V |
To Next Page
