To Next PageTo Next Page
Need help?Do you have a question about the Binder CB Series and is the answer not in the manual?
Requirements for personnel installing, testing, and operating the chamber.
Essential safety guidelines for installation, operation, and avoiding hazards.
Safety guidelines for handling CO2, O2, and N2 gases.
Discussion of unavoidable risks during operation and how to minimize them.
Description of the inner chamber, materials, shelves, and door lock.
Description of the MB2 controller display, touchscreen, and USB interface.
General safety information and precautions for handling gas cylinders.
Overview of water supply methods and dehumidification for CBF/CBF-UL models.
Details on power plugs, voltages, frequencies, and chamber fuses.
Description of controller modes: Idle, Fixed value, Timer, Time, and Week program.
Procedures for entering setpoints via menus or normal display.
How to use the stopwatch function for timed operations.
Steps to create and manage time-based programs.
Steps to create and manage weekly programs.
Entering values and defining setpoint transitions (ramp/step) for program sections.
Detailed list of alarm messages, conditions, and start times.
Configuring tolerance ranges and delay times for alarms.
Basic troubleshooting steps for common chamber issues.
Steps for replacing gas inlet fine filters for CO2, O2, and N2.
Detailed description of the hot-air sterilization cycle and its preparation.
External and internal dimensions for different chamber sizes.
List of standard equipment and available optional accessories.
Requirements for personnel installing, testing, and operating the chamber.
Essential safety guidelines for installation, operation, and avoiding hazards.
Safety guidelines for handling CO2, O2, and N2 gases.
Discussion of unavoidable risks during operation and how to minimize them.
Description of the inner chamber, materials, shelves, and door lock.
Description of the MB2 controller display, touchscreen, and USB interface.
General safety information and precautions for handling gas cylinders.
Overview of water supply methods and dehumidification for CBF/CBF-UL models.
Details on power plugs, voltages, frequencies, and chamber fuses.
Description of controller modes: Idle, Fixed value, Timer, Time, and Week program.
Procedures for entering setpoints via menus or normal display.
How to use the stopwatch function for timed operations.
Steps to create and manage time-based programs.
Steps to create and manage weekly programs.
Entering values and defining setpoint transitions (ramp/step) for program sections.
Detailed list of alarm messages, conditions, and start times.
Configuring tolerance ranges and delay times for alarms.
Basic troubleshooting steps for common chamber issues.
Steps for replacing gas inlet fine filters for CO2, O2, and N2.
Detailed description of the hot-air sterilization cycle and its preparation.
External and internal dimensions for different chamber sizes.
List of standard equipment and available optional accessories.
General| Interior Material | Stainless steel |
|---|---|
| Controller | Microprocessor-based PID controller |
| Power Supply | 230V, 50/60Hz (varies by model) |
| Temperature Fluctuation | ±0.3°C |
| Timer | Programmable timer function |
| Display | LCD or LED (depending on the model) |
| Safety Features | Overtemperature protection |
