What to do if my Binder MKF 115 chamber doesn’t heat up?
If your Binder Laboratory Equipment chamber isn’t heating up, it could be due to a defective heating element, in which case you should contact BINDER service.
What to do for condensation or icing at the sides of the inner chamber of Binder Laboratory Equipment?
If you observe condensation or icing at the sides of the inner chamber, it's likely because the set-point has been below the ambient temperature for an extended period, causing icing in the preheating chamber. Defrost the chamber.
Why am I getting a humidity alarm message when operating without humidity on my Binder Laboratory Equipment?
If you receive a humidity alarm message while operating without humidity (humidity switch OFF), it's because the humidity set-point is set to a value greater than 0% r.H. In Manual Mode, enter a humidity set-point of 0% r.H. In Program Mode, enter a humidity subprogram with a humidity set-point of 0% r.H.
Why is there no or low dehumidification in my Binder MKF 115?
If there is no or low dehumidification, it could be because the capillary tube is blocked. Contact BINDER service.
What causes icing at the sides of the inner chamber in Binder MKF 115?
If there's icing at the sides of the inner chamber, it's likely because the set-point has been below the ambient temperature for too long. Defrost the chamber.
How to resolve humidity fluctuation in Binder MKF 115 Laboratory Equipment?
If the control accuracy of ± 2.5 % r.H. is not reached, it may be due to a defective door gasket. Replace the door gasket.
What to do if there is no dehumidification and a "1H PREHEAT PHASE" notification in the controller display of my Binder MKF 115?
If there is no dehumidification and the notification "1H PREHEAT PHASE" is displayed, it means the rear power switch was turned on less than 1 hour before operating the chamber. Turn on the rear power switch at least one hour before operating the chamber.
What to do if the Binder MKF 115 Laboratory Equipment chamber has no function?
If the Binder Laboratory Equipment chamber has no function and turning on the main power switch has no effect, it means that the rear power switch is not turned on. Turn on the rear power switch at least one hour before operating the chamber.
Why is there no refrigerating performance in my Binder Laboratory Equipment?
If there is no refrigerating performance, it may be because the ambient temperature is greater than 25 °C / 77°F. You should select a cooler place for installation.
What should I do if the safety device class 2 responds in my Binder Laboratory Equipment?
If the safety device class 2 responds, it means the limit temperature has been reached. Disconnect the Binder Laboratory Equipment chamber from the power supply and allow it to cool down. Identify and eliminate the cause of the over-temperature. Press the 'RESET' button on the controller. Restart the chamber and verify the control functions. If necessary, choose a more appropriate limit value.
General| Brand | Binder |
|---|---|
| Model | MKF 115 |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
