Binks 460 - Service Checks; Will Not Spray (A); Poor Pattern (B-C); Wet Finish (D)

8 © 2013 Finishing Brands UK Ltd.
E
SERVICE CHECKS
CAUSE CORRECTION
A
1) No pressure at the gun
2) Piston stops moving
3) Screw 184581 not properly adjusted
A
1) Check air/material lines
2) Clean
3) Adjust
B-C
1) Material build-up on air cap/fluid tip
B-
C
1) Clean air cap/fluid tip
D
1) Material too thick or too much
D
1) Thin or reduce material flow
E
1) Not enough material
E
1) Reduce air pressure or increase material flow
F
1) Insufficient material in tank or an obstruction in
the hose.
2) Loose or damaged fluid tip
F
1) Fill tank or clear obstruction
2) Tighten or replace.
G
1) seal worn 180295
2) Seal retainer 180296 loose
G
1) Replace seal
2) Adjust
H
1) Dry packing 180295
2) Worn or damaged fluid tip 2003** or needle
1800**
3) Seal retainer 180296 tight
H
1) Replace
2) Replace
3) Adjust
Finishing Brands UK Limited,
Ringwood Road,
Bournemouth,
BH11 9LH,
UK.
Tel.No. +44(0)1202 571111
Fax No. +44(0)1202 581940
Website address http:// www.finishingbrands.eu
Registered office:
Finishing Brands UK Limited,
400, Capability Green,
Luton,
Bedfordshire,
LU1 3AE,
UK.
Registered in England: No. 07656273
Vat No. GB 113 5531 50