a l b g
If you are un ab le to or do not wish to ac cept a call, you can re ject the call. Press the »re ject« soft key and the call will
no lon ger be sig nal led to your sys tem te le pho ne. If you are a mem ber of a team, the call is sig nal led to ot her te le pho -
nes in the team. If the call was only sig nal led to your sys tem te le pho ne, Busy is sig nal led to the cal ler after it has been
rejected.
a l
s
re ject
Forwarding a call (Call Deflection)
If you are un ab le to or do not wish to ac cept a call, you can for ward the call. Press the »trans fer« soft key in or der to
for ward the call di rect ly to anot her ex ten si on. The call num ber to which the call is due to be for war ded can be pre set
in the sys tem te le pho ne con fi gu ra ti on for each call number (MSN).
Af ter pres sing the »trans fer« soft key you can eit her for ward the call to the pre set call num ber or en ter a new call
number.
a l
s
t
O
trans fer
Dial call num ber
<$I[English]Initiate call;Without call number (CLIR)>Suppressing the call number
(anonymous call)
If you do not want your call num ber to be sent to the cal led par ty, you can sup press the trans mis si on of your call num -
ber. You can set this functi on spe ci fi cal ly for the next call or per ma nent ly (see page ).
Sup pres sing trans mis si on of the call num ber for the next call
You can per form in ter nal or ex ter nal di al ling so that the call num ber (MSN) is not trans mit ted from your sys tem te le -
pho ne to the cal led party.
a t
O M s
b g
Dial
con cea led
If a call is sig nal led, you can de ci de be fo re ac cep ting the call whet her or not your call num ber should be trans mit ted to
the cal ler. If your sys tem te le pho ne is the des ti na ti on of a call di ver si on, you can use this pro ce du re to pre vent the call
see ing the call num ber of the di ver si on destination (your number).
a l
s
b g
con cea led
Initiating a call with a fixed call number (MSN)
You can per form in ter nal or ex ter nal di al ling so that a spe ci fic num ber is trans mit ted from your sys tem te le pho ne to
the cal led par ty. This call num ber must first be en te red in your sys tem te le pho ne. Du ring se lec ti on you will see the
call num ber trans mit ted (»MSN-1«...»MSN-10«) or the name you have as sig ned to this call num ber (MSN).
You can in itia te di al ling with a fi xed num ber as des cri bed below or use a programmed function key.
,
In the WIN-Tools pho ne book ma na ger you can as sign an out going num ber (MSN) to each re cord.
a t
O M s s
b g
Dial call num -
ber
MSN MSN-1 …
MSN-10
Te le pho ning Forwarding a call (Call Deflection)
24
To Next Page
Loading...