BinTec elmeg CS410 - Unpacking and Positioning the System Telephone; Unpacking and Initial Setup

Un pa cking and po si tio ning the sys tem te le pho ne
Un pa cking
· Sys tem te le pho ne.
· Re cei ver with cord.
· 2 de vi ce feet.
· S-con nec tor cord, ap prox. 6 m (only elmeg CS410 and CS410-U).
· Cat.5 con nec tor cord, ap prox. 2 m (only elmeg CS410 and CS410-U).
· PC con nec tor cord, USB ca ble, ap prox. 3m (only elmeg CS410 and CS410-U).
· PC au dio cord, 3.5mm ste reo jack plug, ap prox. 2.5m (only elmeg CS410 and CS410-U).
· Adap ter ca ble for he ad sets with 4-pin cord, 8-pin / 4-pin.
· Ca ble clip, af ter re mo ving the ad he si ve pro tec ti ve film (only elmeg CS410 and CS410-U).
· User’s gui de and la bels for functi on keys.
· WIN-Tools CD-ROM, in clu ding:
Pro fes sio nal Con fi gu ra tor, pho ne book, downlo ad and sound ma na gers,
TAPI, USB, CAPI and NDIS WAN dri vers, Ado be Acro bat Rea der,
Operator’s ma nu al and Ado be Acro bat file for prin ting your own labels.
Setting up the system telephone
Be fo re set ting up the rear de vi ce feet must be moun ted on the sys tem te le pho ne in the po si tions mar ked
6
in the pic -
tu re.
Plea se re mem ber that the sys tem te le pho ne de vi ce feet may lea ve marks on de li ca te sur fa ces, such as on fit tings for
ex am ples. The sys tem te le pho ne ma nu fac tu rer shall not be li ab le for any such da ma ge. Plea se en su re the re fo re that
you pla ce your system telephone on a non-slip surface.
Cleaning the system telephone
The sys tem te le pho ne has been de sig ned for nor mal usa ge con di tions. Only cle an the de vi ce when ne ces sa ry with a
slight ly damp cloth or use an anti-sta tic cloth. Ne ver use sol vents. Ne ver use a dry cloth; the elec tro sta tic char ge could
cau se elec tro nic faults. Make sure that no moi stu re can en ter the sys tem telephone and cause damage.
Connecting the system telephone (connector and receiver cord)
In or der to ope ra te your sys tem te le pho ne, you must in sert the cords for the te le pho ne con nec tor and the receiver.
Connecting the receiver cord
Con nect the re cei ver cord
1
as shown in Fig. . Pla ce the re cei ver cord in the ca ble gui de
4
and clamp it se cu re ly un -
der the ca ble clips
5
Un pa cking and po si tio ning the sys tem te le pho ne Extensions for the system telephone
8