BIO RAD MyCycler - Page 5

6.1.1 Run Setup Screen 23
6.1.2 Run Screen 24
6.1.3 Running Gradient Protocols 25
6.1.4 Converting a Gradient Protocol 25
6.2 Options While a Protocol is Running 26
6.2.1 Displaying the Home Screen while a Protocol is Running 26
6.2.2 A Power Failure while a Protocol is Running 26
6.2.3 Pausing a Running Protocol 27
6.2.4 Terminating a Running Protocol 27
6.2.5 End of Run Screen 27
Section 7 Reports 28
7.1 The Run Report 28
7.2 The Validation Report 28
7.3 Soft Key Functions for Reports 28
7.4 Uploading Reports 29
Section 8 Utilities 30
8.1 The Utilities Menu 30
8.1.1 View Reports 30
8.1.2 Instrument Information 30
8.1.3 Set Date and Time 30
8.1.4 Set Display Contrast 30
8.1.5 Service Options 30
8.2 The Set Preferences Menu 30
8.2.1 Default Hot Start Options 30
8.2.2 Default Temperature Measurement Mode 31
8.2.3 Default Sample Volume 31
8.2.4 Idle Temperature Measurement Mode 31
8.2.5 Lid Temperature Control 31
8.2.6 Auto-Standby Options 31
8.2.7 Instrument Name 32
8.2.8 Beeper Options 32
Section 9 The Help Screen 33
9.1 Soft Key Functions for the Help Screen 33
Section 10 Care and Maintenance 33
10.1 Cleaning the Unit 33
10.2 Replacing a Fuse or a Battery 33
10.3 Troubleshooting Procedure 34
10.4 Error Messages 35
Appendix A Specifications 36
Appendix B Product Information 38
^
IV