BIO RAD MyCycler - Powering Up and Standby Mode; 1.3.3 USB Cable Connection; 1.3.4 Powering Up and Shutting Down; 1.3.5 Standby Mode

••>
^
1.3.3 USB Cable Connection
In addition to the power cable connector, the rear panel of the MyCycler contains
a USB port that may be connected to a personal computer, allowing the transfer of
protocol files, Validation Reports, and Run Reports. Using this link, you may print
out any downloaded protocols or reports if the PC is connected to a printer. The USB
link is not necessary for running the instrument. —.
1.3.4 Powering Up and Shutting Down
Before powering up the MyCycler, place it in a location that has sufficient
ventilation and access to the reaction module and keypad. We recommend at least
4" (10 cm) clearance to the left, right, and rear of the instrument. For convenience,
about 14-15" (36-38 cm) clearance from the bench surface is needed to open the
lid.
To turn the MyCycler on, press the "Standby" button on the front panel of the
instrument once. A green LED next to the Standby button glows when the
instrument is on and receiving power. To shut down the MyCycler completely,
simply unplug the power cord from the power outlet. An alternative to system
shutdown is Standby mode.
1.3.5 Standby Mode
To conserve power, the MyCycler has a user-programmable standby option.
The green LED next to the Standby button blinks to indicate that the MyCycler is in
Standby mode. This option will turn off all non-essential operations in an idle
instrument, including the LCD screen, heated lid, and sample block temperature
control. The fan will turn-off when the internal temperatures have equilibrated.
Auto-Standby settings for the instrument may be programmed as described in
Section 8.2.6. When in Standby mode, briefly press the Standby button once to
turn the instrument back on.
Standby mode can also be initiated by holding down the blue Standby button
once for 3 to 4 seconds. The instrument will go into Standby mode unless you are
running a thermal protocol or have made unsaved changes to a protocol. If you are
running a thermal protocol or have made unsaved changes to a protocol, you will
be asked to verify the standby selection. ^-^
Note: Acceptance of standby initiation will terminate or abandon edits for the active
protocol.