Picture 3
Notes:
1) Check the package after receiving the device. Broken glass or other visible damage must be
indicated in the equipment receipt, and immediately notify the shipper.
Note: Equipment cannot be returned to the factory, unless receive return authorization!
2) If the device is transported in cold weather, please place it in the area for 24 hours at room
temperature before putting it in working place. Please move the equipment as close as possible to
where you use it before dismantling packing.
3) Firstly, remove all surface protection. Before the entire device is exposed, do not try to lift off the
packing bracket, and make sure you have read the article as below.
4) Unpack the entire package; put away all components for assembly carefully. Left adhesive tape
can be wiped with alcohol.
5) Check all parts. If there is damage, please notify the transport company immediately. If the
device has problem, do not open the package, because shipper may need to check boxes.
6) Move the equipment off from collet, loosen locking block on the four corners.
7) Safety cabinet is very heavy and is equipped with HEPA filter. They should be transported lightly,
It is better to use big trolley to move the safety cabinet and don’t focus the whole weight of safety
cabinet at the middle of the work place.
8) Sometimes we need to raise the edge of the cabinet to enter some area, but this is only allowed of
a short distance.
9)It is forbidden to make it top-for-bottom or dumping while transporting or placing the Biosafety
Cabinet.
To Next Page
Loading...
