biodex BALANCE SYSTEM SD - Declaration of Conformity


64=2C2E:@?@7@?7@C>:EJ
>:DD:@?D
$+*+((.)"(*!%$"*(%#$*!#!))!%$)
The Balance System SD is intended for use in the electromagnetic environment specified below. The
customer or the user of the Balance System SD should assure that it is used in such an environment.
>:DD:@?E6DE @>A=:2?46 =64EC@>28?6E:46?G:C@?>6?E
RF emissions CISPR 11 Group 1 The Balance System SD generates RF energy
only for its internal functions. Therefore, its RF
emission is very low and is not likely to cause
any interference in nearby electronic equipment
RF emissions CISPR 11 Class A The Balance System SD is suitable for use in all
establishments other than domestic and those
directly connected to the public low-voltage
power supply network supplying buildings
used for domestic purposes.
Harmonic distortion Class A
EN 61000-3-2
Voltage fluctuations Complies
and flickerEN 61000-3-3
>>F?:EJ
$+*+((.)"(*!%$"*(%#$*!!##+$!*-
The Balance System SD is intended for use in the electromagnetic environment specified below. The
customer or the user of the Balance System SD should assure that it is used in such an environment.
>>F?:EJE6DE   =64EC@>28?6E:4
)6DE=6G6= @>A=:2?46=6G6= 6?G:C@?>6?EM8F:52?46
Electrostatic discharge ± 6 kV contact Contact ± 6 kV Floor should be wood,
concrete or ceramic tiles.
If floor is covered with
synthetic material, the
relative humidity should
be at least 30%
Electrical fast ± 2 kV for power lines Power ± 2 kV Mains power quality
transients/burst ± 1 kV for Signal ± 1 kV should be that of a
IEC 61000-4-4 input/output lines typical commercial or
hospital environment
Surge ± 1 kV differential mode ± 1 kV diff. mode Mains power quality
IEC 61000-4-5 ± 2 kV common mode ± 2 kV com. mode should be that of a
typical commercial or
hospital environment
CONTENTS
APPENDIX E — E-2 —