7
. To clear any misplaced or unwanted targets, touch <Clear Target>. Each time this key is
pressed, the most recent target added to the screen will be removed.
8. Touch <More Options> to advance to the Postural Stability Training Options screen if
desired. Here you can set the total time for the exercise, enter initial and ending platform sta-
bility settings, turn tracing ON/OFF and Scoring Tone ON/OFF. Touch <OK> to confirm
y
our selections and return to the Postural Stability Training Options screen, or <Cancel> to
return to the Postural Stability Training Options screen without making changes.
• Use the <
▲> or <▼> keys to set the total time in 10-second increments (during the routine
the software will count down from the time setting selected).
• To turn tracing ON/OFF, touch <Tracing> to toggle between choices. Same for Scoring Tone.
9. Explain the training protocol to the patient and then press <Start> on the display to begin the
training session. The Stability Training grid on the screen charts the patient’s stability perfor-
mance through the course of the training session (touch the <Magnifying Glass> to enlarge
the screen if desired).
NOTE: If you have selected to enlarge the screen by touching the <Magnifying Glass>, you must
return to the normal viewing screen format to make any changes.
10. At any time during the training session, the “tracing” can be erased by pressing <Clear
Tracing>.
11. To stop the training session at any time, press <Stop> on the display.
12. On all training screens tracing will automatically be drawn when the exercise is complete.
When you
are
finished reviewing
the
training screen,
touch
<Print> to
print
the
screen (if
connected to a printer), or <Save Results> to save the training session (numeric data only).
13. After printing or reviewing the screen, press <Start> to immediately begin another training
session using the same parameters, or press <Back> to return to the Training Setup screen.
— 6-3 — THE TRAINING MODES
COMPUTER PRELIMINARIES
To Next Page
Loading...
