10
Figure 10: Mounted PC Power Adapter and Power Strip
Cable Management
The wire loom, zip ties, mounting bases, and fasteners are used for cable management.
1. Measure the length needed for the specific monitor size.
2. Remove the wire loom from packaging and cut two 4-foot long sections with scissors
Note: The length of wire loom needed will differ depending on the Monitor Display size.
3. Using one of the wire loom pieces, open the split seam on the wire loom and insert in the HDMI Cable and Touchscreen
USB Cables. See Figure 11.
Figure 11: Inserting Cables into the Wire Loom
4. Remove the protective covers from five mounting bases and attach the bases to the back of the Display Monitor. See
Figure 12 for suggested attachment locations. The number of mounting bases used and the attachment position will
vary depending on the Display Monitor size.
5. Feed the zip ties through the openings in the mounting bases. See Figure 13.
6. Secure the zip ties around the wire loom and tighten. See Figure 13. Cut off the excess zip tie material with scissors.
7. Create a loop with the HDMI cable, and secure it to the mounting base and tighten. Cut off the excess zip tie material
with scissors
Caution: Be careful when cutting the zip tie material near electrical cables.
8. With the second piece of wire loom, open the split seam on the wire loom and insert in the PC Power Cord and
Touchscreen Display Monitor Power Cord. See Figure 14.
Seam
Insert Cables
Power Strip
To Next Page
Loading...
