BionX Bicycle - Programming the Basic Settings; Enter Programming Mode

20
Programming the Basic Settings
In general, all settings of your BionX electric propulsion system are pre-set. Basic display functions can
be set by entering the programming mode. Contact your dealer to customize the advanced functions of
your system.
Turn on the programming mode
Simultaneously push and VOUJMUIFEJTQMBZTIPXTiw5IFmSTU[FSPCMJOLT$IBOHFUIFWBMVF
of the selection with or and confirm with . Select the other digits in the same manner until the
desired program is displayed.
Note: For G1 programming, substitute NPEFBOE DSPOPGPSQPXFSBOEDZDMF
respectively, and remain the same.
Code Description
2001 4FMFDULNIPSNQI
2002 3FHFOFSBUJPOCSBLFPVUQVUGPSSFFETXJUDIJEFBMMZ
2004 Clock adjust
2005 5JSFDJSDVNGFSFODFNJMMJNFUFST
2009 'MJQ%JTQMBZQPXFSMFGUQPXFSSJHIU(POMZ
Code 2001 Code 2002 Code 2004
4FMFDUVOJULNIPSNQI4FMFDUXJUI
or , and confirm with .
%FGBVMUWBMVF$IBOHFXJUI
and
. Confirm with .
4FMFDUIPVSNJOVUFTXJUI
,
change value with
and .
Confirm with
.
Code 2005 Code 2009
4FUUJSFTJ[FJONN4FMFDUEJHJUT
one after another with
or , and
confirm with
.
Current setting of main functions is
EJTQMBZFE'MJQBTTJTUUPHHMFJT
on
UIFSJHIUTJEFPGDPOTPMF'MJQ
assist
toggle is on the left side of console.
Confirm with
.
WARNING
Do not use other programming codes without consulting your authorized dealer.
If you type the wrong code, please push the key to exit programming mode.
english