21
STEP 1-1. Insert batteries
1. Ensure the analyzer is switched o and turn it over.
2. Open the battery compartment lid by slightly pressing the tab towards the centre of
the analyzer.
3. -JGUUIFMJEVQXBSETUPSFNPWFJUGSPNUIFBOBMZ[FS
4. Insert four batteries into the compartment according to the illustrations. Please
note the orientation of the “+” (battery head) and “–” terminals (at end). Use only
alkaline manganese batteries (1.5 V, AA).
5. Close the battery compartment lid.
6. Turn the analyzer on to test the function of the new batteries.
7. Check that the display is functioning correctly to prevent misinterpretations due to
defective display elements.
STEP 1-2. Connect AC adapter jack
1. Ensure the AC adapter jack is provided by SD Biosensor, inc.
(AC adapter jack is 4 mm external-diameter and 1.7 mm internal-diameter, and
output is 5V/2A.)
2. Connect AC adapter jack to the AC jack port in the back of analyzer.
Always replace all four batteries at the same time because batteries with different
capacities may impair the function of the analyzer. Do not use rechargeable batteries.
t If you think the display screen does not appear for long enough, you can
hold down the Enter button (the next time you switch on the analyzer). The
display screen is then shown for the time the button is pressed.
t After inserting or replacing batteries, conrm that the time and date are set
correctly. If they are not, reset the analyzer before testing.
t If the batteries are already inserted and if AC adapter jack is connect, the
analyzer use a power only from AC adapter.
To Next Page