Need help?Do you have a question about the Biotek 800TSI and is the answer not in the manual?
General| Type | Microplate Reader |
|---|---|
| Wavelength Range | 200-1000 nm |
| Light Source | Xenon flash lamp |
| Absorbance Range | 0-4 OD |
| Microplate Types | 6-384 well plates |
| Shaking | Yes, orbital and linear |
| Software | Gen5 |
| Detection Modes | Absorbance |
| Plate Formats | 6-, 12-, 24-, 48-, 96-, 384-well |
| Weight | 25 kg |
Contact information for technical assistance.
Emphasizes the importance of QC for accurate results.
General warnings about operation, environment, and potential hazards.
Requirements for power supply and electrical grounding.
Warnings related to service, accessories, lubricants, liquids, and use.
Warnings about hot surfaces, voltage, biohazards, and environmental conditions.
Cautions regarding service, spare parts, touchscreen, and power supply.
Step-by-step guide to removing shipping hardware.
Procedure to check filters in the filter wheel.
Instructions for connecting the instrument's power supply.
Check if the filter table matches installed filters.
Confirm filter values in the system match the physical filter wheel.
Troubleshooting steps for communication failures.
Procedure for running system tests via the touchscreen.
Procedure for running system tests using Gen5.
Safety guidelines before performing maintenance procedures.
Measurement range, resolution, accuracy, linearity, repeatability for standard models.
Specs for UV models including wavelength range and accuracy.
Resolution, accuracy, linearity, repeatability for NB models.
To Next Page
