34 Changing a Fuse
Changing a Fuse
The fuses are located in a fuse drawer below the
connection for the power supply.
Caution! Before changing the fuses, you must turn off the
ICS 3000 and unplug the power supply cable.
• To unlock the drawer, push the latches at the right and
left of the drawer inwards together.
• Pull the drawer out.
• Replace the old fuses with new ones of the same type.
The type of fuse is marked on the fuse itself; see also
„Power Supply“ on page 38.
Caution! Defective fuses may indicate a technical defect in the
device. Conduct a type B inspection.
Disposal
This device contains materials that must be correctly
disposed of in accordance with environmental
protection regulations. European Directive 2002/96/
EC regarding waste electrical and electronic
equipment (WEEE) applies to this device.
• Send the devices you are no longer using to the local
BIOTRONIK representative. This ensures that disposal
will be carried out in accordance with the national
versions of the WEEE directive.
This device contains a crossed-out garbage can
symbol on its label. This requires the device to be
collected and disposed of in accordance with the
WEEE directive. The black bar underneath the
garbage can symbol indicates that the device was sold
after the national version of the WEEE directive in your
country was implemented in your country.
• Should you have any questions, please contact
BIOTRONIK.
To Next Page
Loading...
