The door may need to be adjusted to
be completely airtight. For a door to
be considered air tight, a piece of
paper cannot be inserted in between
the façade of the fireplace and the
door gasket. The gasket air
tightness can be adjusted using the
adjustment screw located on the
fireplace façade at the bottom of the
fireplace opening. (An Allen key #
1/8 will be necessary for
adjustment).
3.3.10 Glass Care - Replacement
The glass used for the BIS PANORAMA is a high temperature ceramic glass. If the glass
breaks, it must be replaced with a ceramic glass. Tempered glass or ordinary glass will not
withstand the high temperatures of the BIS PANORAMA. Replacement ceramic glass
should be purchased from a Security Chimneys International dealer. Do not operate the
unit with cracked or broken glass.
3.3.11 Glass Care - Cleaning
The BIS PANORAMA is designed to keep the glass clean under normal operating
conditions. If the BIS PANORAMA is operated continuously with the combustion air
damper closed, the glass will tend to get dirty unless the fuel, firebox and glass are
maintained at hot temperatures (see "Refuelling For Best Performance”). To clean the
glass, there are a number of specially designed cleaners. Your authorised Security
Chimneys International dealer can recommend a suitable cleaner which is available in your
area. Regular household glass cleaners will not clean creosote. Do not use abrasives such
as steel pads, steel wool or oven cleaner as they will scratch the glass.
3.3.12 Gasket Replacement
Remove the door from the unit (see page 14) and lay it on a clean unabrasive surface. To
replace the gasket, first remove all of the old gasket and gasket cement. Make sure that
the surface is totally clean before applying new cement or adhesion problems may result.
Apply gasket cement to the gasket channel and install the new gasket. This replacement
part is available from your Security Chimneys International dealer in the following
dimensions:
To Next Page
Loading...
