(2) If “VMSM Selection” is selected
The following lines will be printed when the VMSM opens.
** VMSM Selection **
0 : Exit and reboot printer
(*) 1 : None
2 : Set Print Density
3 : None
4 : Set Cutting mode
5 : Set External Buzzer after
cutting
6 : None
7 : None
8 : Print current settings
9 or more : None
(*) SRP-E300ES/E302ES
1: Ethernet Information Setting
Press the Feed button to run the above function.
Step 1(Select Options): press the button a number of times as shown by each
menu.
Step 2(Enter Options): hold down the button for at least one second to apply
each item selected.
- If you select any items not listed above, the list of “VMSM Selection” will be
printed
again. Setting the mode will be canceled if no item is selected in Step 1.
- If the "0: Save settings and exit" function is not executed,
The setting information is not stored in the printer.
Hold down the Feed button for at least 1 second to save the changes.
The following line will be printed before cutting the paper.
6) The new settings will be automatically applied when printer resets.
To Next Page
Loading...
Need help?
General
