BK Precision 830C - CALCulate Average State Command; CALCulate Limit Subsystem

85
Example:
CALC:AVER:MAX? ; Query the maximum
recorded value.
CALC:AVER:MIN? ; Query the minimum
recorded value.
CALC:AVER:AVER? ; Query the average
recorded value.
CALC:AVER:PRES? ; Query the present
recorded value.
Note: If static recording function is disabled, all
queries will return an error message on display
until the function is re-enabled again. Use
CALCulate:AVERage:STATe command shown
below to control static recording function.
CALCulate:AVERage:STATe <Boolean>
Description: Enable or disable the static
recording function of the calculation.
Example: CALC:AVER:STAT OFF
CALCulate:LIMit
:MODE <mode>
:LOWer <mode>, <value>
:UPPer <mode>, <value>