RELM Wireless Corporation
- 36 -
Zone Scan (ZSCN)
NOTE: To activate Zone Scan, Channel Scan must be turned on.
When Zone Scan is turned on the
Z
P
icon is displayed and the radio
scans all programmed scan channels in zones programmed as Zone
Scan zones.
Toggle switch operation
On - Slide the programmed switch toward the front of the radio.
Off - Slide the switch up toward the channel select switch.
Button Operation
On - Press the programmed button.
ZSCN
Off - Press the button again.
ZSCN
Menu Operation
Press the assigned Menu button 1.
MENU
.
Use the up/down buttons 2. to select “Zone Scan”.
Press the ENT button 3. .
Use the up/down buttons 4.
to select On or Off.
Press the ENT button 5. to set the selection.
Hold the ESC button 6. to return to normal operation.
Zone Scan List Add/Delete (ZSC+)
A menu item or button can be programmed to add or remove Zones to
the Zone Scan List.
Button Operation
To add or remove a channel from the scan list:
Turn to the channel you wish to add or delete.1.
Press the programmed button. 2.
ZSC+
To edit the Scan List from the Menu:
Press the Menu button. 1.
MENU
Use the up/down buttons 2. to select “Zone Scan List”.
Press ENT 3. . The list of available zones will be displayed.
Zones preceded by 5 are currently in the zone scan list.
indicates a Zone not in the zone scan list.
Use the up/down button 4.
to select the desired Zone. Or
enter the zone number with the numeric keypad.
Use the +/- button to add or delete the Zone from the Scan List. 5.
Hold the ESC button 6.
to return to normal radio operation.
To Next Page
Loading...
Need help?
General
