Gas Pressure Fryer Operation
19
STEP ACTION DISPLAY COMMENTS
13 Repeat steps 5-12 when
programming stages 2, 3, 4 and
5 for Electric and Gas appliance
types.
Repeat steps 5-10 when
programming stages 2, 3, 4 and
5 for an ALF appliance type.
The time and temperature of each
stage has to be less than the
preceding stage.
14 Press ENTER. PROGRAM PREALARM
00:00
This command allows you to
specify the number of minutes
before the end of the cooking time
(for each stage) until the alarm
sound The prealarm value
displayed may be a previously
programmed value.
15 Press TOGGLE/CLEAR and
input the prealarm minutes.
PROGRAM PREALARM
XX:XX
XX:XX refers to the prealarm
minutes you input.
16 Press ENTER. PROGRAM FILTER
0
This command allows you to
specify the number of fry cycles
you want to complete for this
program before a message is
displayed reminding you to filter
the shortening (filter lockout). The
filter value displayed may be a
previously programmed value.
17 Press TOGGLE/CLEAR and
input the number of fry cycles
you want to complete before
enabling filter lockout.
PROGRAM FILTER
X
X refers to the number of program
cycles you want to complete before
filtering the shortening.
18 Press ENTER. PROGRAM PRODUCT #
19 If you wish to input more
programs, proceed by pressing
the next program number and
follow steps 5 through 18 or
press PROG to exit the
programming mode.
Start-Up (LGF-FC)
1. Make sure the main drain valve is closed.
2. Fill pot with shortening to about one inch below the mark.
Use only high-quality shortening that has low moisture content, a high smoke point and
no additives.
Overfilling the fryer pot with shortening could lead to serious injury. Ensure that the fryer
pot is filled with shortening only to the fill mark when shortening is hot. Do not use any
shortening other than what is specified in this manual and do not overfill the fryer pot.
3. Place the gas control ON/OFF switch in the ON position.
To Next Page
Loading...
