724-746-5500 | blackbox.com
Page 20
Chapter 4: Installing the Switch
Inserting an SFP Transceiver into a Slot
Figure 4-6. Inserting an SFP transceiver into a slot.
To install an SFP transceiver, do the following:
Step 1: Consider network and cabling requirements to select an appropriate SFP transceiver type.
Step 2: Insert the transceiver with the optical connector facing outward and the slot connector facing down. Note that SFP
transceivers are keyed so they can only be installed in one orientation.
Step 3: Slide the SFP transceiver into the slot until it clicks into place.
NOTE: SFP transceivers are ordered separately.
4.6 Connecting to a Power Source
You can plug or remove the power cord from an AC power socket to switch the power on and off.
FIgure 4-7. Inserting the power cord into an AC power socket.
Step 1: Insert the power cable plug directly into the AC Socket located at the back of the switch.
Step 2: Plug the other end of the cable into a grounded, 3-pin, AC power source.
Step 3: Check the front-panel LEDs as the device is powered on to be sure the POWER LED is lit. If not, check that the power
cable is correctly plugged in.
WARNING: For International use, you may need to change the AC line cord. You must use a line cord set that has been approved
for the socket type in your country.
To Next Page
Loading...
