724-746-5500 | blackbox.com
Page 22
Chapter 4: Installing the Switch
4.8 Web-Based Management
The default values of the managed switch are listed in the table below:
IP address 192.168.1.1
Subnet Mask 255.255.255.0
Default 192.168.1.254
Username admin
Password
After you configure the switch in the Command-Line Interface (CLI) via the switch’s serial interface, you can browse it. For
instance, type http://192.168.1.1 in the address row in a browser. It will show the following screen and ask you to input a user-
name and password to login and access authentication. The default username and password are both “admin.” The first time you
login to the switch, enter the default username and password, then click the <Login> button. The login process now is complete.
Figure 4-10. Gigabit Managed PoE+ Switch Web user interface.
NOTE: To configure a function or parameter on the switch, refer to the user manual. Or, access the switch and click the “help”
button under the Web GUI and help screens will pop up.
To Next Page
Loading...
