ENGLISH
BLACKSTONEPRODUCTS.COM
OWNER’S MANUAL | ASSEMBLY GUIDE MODEL: 2379
STEP 02
Insert one (1) AA battery (not included) under the
battery cap.
Screw the cap into place over the positive terminal.
STEP 03
Use two (2) M4x10 screws [a.] to attach the bale panel to
the front panel.
Install the control knob by pushing it into place in the OFF position.
STEP 05
Slide the door shaft seat (R) onto the door shaft.
Screw the door handle onto the door shaft.
STEP 04
Set the pizza oven on its feet.
Align the pizza stone with the turn table notches and use the hexag-
onal wrench and one (1) M6x24 screw [b.] to secure.
To Next Page
Loading...
