BLACKHAWK! PL10C - User Manual

Questions and Answers

G
gscottAug 4, 2025
What to do if my BLACKHAWK! Scissor Lift does not rise?
- B
  Brandon BuchananAug 5, 2025
  If your BLACKHAWK! Scissor Lift doesn't rise when you press the lifting button, there are several potential causes. First, check the fuse and replace it if it's burnt out. The lift might be overloaded, so reduce the load to the maximum weight specified. Also, the hydraulic oil level might be too low, in which case you should fill it. If these steps don't resolve the issue, there may be a fault in the electrical system or the switch might not be working, and you should call a dealer for service or to replace the switch.
R
richardheatherAug 12, 2025
Why my BLACKHAWK! PL10C doesn't lift the whole way?
- D
  Deanna CollierAug 12, 2025
  If your BLACKHAWK! Scissor Lift isn't lifting all the way, it could be due to a couple of reasons. The lift might be overloaded, so ensure you're maintaining the maximum weight according to the specifications. Also, check the hydraulic oil level and fill it if it's too low.
R
Ross KellyAug 18, 2025
What to do if BLACKHAWK! PL10C Scissor Lifts doesn't respond while pushing the descent button?
- C
  Chase HortonAug 18, 2025
  If your BLACKHAWK! Scissor Lift doesn't respond when pushing the descent button, it could be due to a defect in the electric system; in this case, you should call a dealer for service. Alternatively, an obstacle might be preventing the mobile leg of the lift from moving. Remove any object preventing the movement, and thoroughly clean and grease the surface on which the mobile leg moves by means of the bearings.
J
Jessica ChenAug 27, 2025
Why BLACKHAWK! PL10C Scissor Lifts platform moves downwards when descent button is not pushed?
- J
  Jennifer BurtonAug 27, 2025
  If the platform of your BLACKHAWK! Scissor Lift moves downwards without the descent button being pushed, it could be due to a leakage in the hydraulic system, a dirty hydraulic cylinder, or a leaking non-return valve. In any of these cases, you should call a dealer for service.