Blackmagicdesign SmartView Duo Operation Manual

Installation
18
Software: Configuring Blackmagic SmartView Utility software
After installing the Blackmagic SmartView Utility software, launch the Blackmagic SmartView Utility and
it should immediately search your network for any SmartView Duo units by using the Bonjour service
discovery protocol. Any discovered units will be listed in the SmartView Monitors pane with an Ethernet
network icon next to their name. Select the name of the desired SmartView Duo and you will be able to
change the device name and also the monitor settings for each monitor on each SmartView Duo. Network
settings will remain grayed out and can only be changed via USB.
SmartView Duo with an Ethernet network icon next to
its name.
The Blackmagic SmartView Utility automatically searches your network for any SmartView Duo units. Only one unit has
been found in this picture.
Blackmagic SmartView Utility application icon

Blackmagicdesign SmartView Duo Specifications

General

Brand	Blackmagicdesign
Model	SmartView Duo
Category	Monitor
Language	English