Connectors
1 Mini-B USB Port
Connects to the Blackmagic Teranex Setup software via a Mac or Windows computer
for adjusting settings and updating your Teranex Mini’s internal software.
2 Switches
Adjustable switches for changing settings.
3 LED Status Indicator
Glows white when the converter is receiving power and green when a valid video input
signal is detected. Will flash on/off to identify individual converters via Blackmagic
Teranex Setup.
4 Power
Standard built in IEC C14 connector for 90 - 240 volt AC power supply.
5 HDMI
HDMI video output.
6 Ethernet PoE+
Connects to a network switch or computer so you can change settings using the
Teranex setup utility. TheEthernet port also supports power over Ethernet plus.
7 SDI In
SDI video input BNC connector.
8 SDI Loop Out
SDI video loop output BNC connector.
9 L – Analog or AES/EBU
Balanced left channel analog audio, or digital AES/EBU audio output XLR connector.
10 R – Analog, AES/EBU or Timecode
Balanced right channel analog audio, or digital AES/EBU audio output XLR connector.
Can also be configured for timecode output.
Switches
Teranex Mini - SDI to HDMI 12G’s switches provide the following settings:
Switch 8 - Analog Audio, AES/EBU Audio
Set switch 8 to ‘off’ to output balanced analog audio. Set to ‘on’ for digital AES/EBU audio.
Switch 7 - Output Audio/Timecode
Set switch 7 to ‘on’ to output timecode via the R channel audio XLR connector. Set to ‘off’ to
output audio.
Switches 4, 3, 2 - SDI Audio De-Embed Bit 2, 1, 0
Switches 4, 3 and 2 are represented as bits 2, 1, and 0 respectively. This simply means that by
setting various on/off combinations for switches 4, 3, and 2, you can choose which pair of audio
channels from your SDI input you would like to output to HDMI, analog or AES/EBU audio.
25Teranex Mini – SDI to HDMI 12G
To Next Page
Loading...
