What to do if BLACKMER LB361B has no flow?
If your BLACKMER Air Compressor has no flow, drain the liquid trap through the drain valve and relieve vacuum through the bleeder valve on top of the liquid trap. If excess flow valves are slugged, stop the compressor to allow them to open. You might need to install a valved bypass line between the suction and discharge lines.
What to do if my BLACKMER Air Compressor has no oil pressure?
If your BLACKMER Air Compressor shows no oil pressure, there are several potential causes. First, the oil pump might not be working; in this case, set the oil pump relief valve. Also, examine the oil pump drive tab or stop pin for any signs of damage. Check and replenish the oil level if it's low. Finally, a dirty inlet strainer can also cause this issue, so clean the inlet strainer.
Why does the relief valve actuate on my BLACKMER Air Compressor?
If the relief valve actuates in your BLACKMER Air Compressor, ensure that the valve downstream of the compressor is open. Also, check for and correct any line blockages downstream from the compressor.
What to do if BLACKMER LB361B has no oil pressure?
If your BLACKMER Air Compressor has no oil pressure, start by setting the oil pump relief valve correctly. Then, inspect the oil pump drive tab or stop pin for any damage. Check the oil level and replenish if it's low. Lastly, clean the inlet strainer to ensure it is free from dirt.
How to fix low transfer rate in BLACKMER LB361B?
To address a low transfer rate in your BLACKMER Air Compressor, begin by lubricating the 4-way valve with a compatible stick lubricant. If the issue persists, inspect the piston rings by restricting the discharge line; a slow pressure increase indicates faulty rings. Also, check for and clean any plugged strainers. Examine the compressor valve for damage, and adjust the liquid relief valves as per the instructions in "Valve Replacement". Ensure the compressor drive isn't slipping by tightening belts and checking for sheared or loose keys, or a loose flywheel. Finally, verify that the piping is correctly sized and installed.
What causes a BLACKMER LB361B open valve?
A BLACKMER Air Compressor open valve can be caused by a line blockage downstream of the compressor. Locate the blockage and correct it.
What causes improper mounting or vibration in a BLACKMER LB361B?
Improper mounting or vibration in your BLACKMER Air Compressor can occur due to loose or broken mounting or anchor bolts; refer to 'Mounting the Compressor Unit' and ensure the base is fully supported. It can also be caused by improperly aligned V-belt sheaves; see 'V-Belt Drives'. Another potential cause is an improperly installed flywheel; consult 'Compressor Flywheel'. Additionally, faulty valves can contribute to vibration, so replace or repair them as needed.
What to do if my BLACKMER LB361B has excess flow?
If your BLACKMER Air Compressor experiences excess flow due to slugged flow valves, installing a valved bypass line between the suction and discharge lines may be necessary.
What to do if my BLACKMER Air Compressor has a liquid trap full?
If the liquid trap in your BLACKMER Air Compressor is full, drain it through the drain valve and relieve vacuum through the bleeder valve on top of the liquid trap. You can also stop the compressor to let the excess flow open.
What to do if my BLACKMER LB361B Air Compressor has knocks or other noises?
If your BLACKMER Air Compressor is making knocking or other unusual noises, it might be due to worn internal parts. Inspect the internal parts through the inspection plates and repair as necessary.
Essential checks before starting the compressor.
Step-by-step instructions for starting the compressor.
Specific torque values for various compressor bolts.
Procedures and recommendations for lubricating the compressor.
How to adjust and verify the oil pressure.
General| Brand | BLACKMER |
|---|---|
| Model | LB361B |
| Category | Air Compressor |
| Language | English |
To Next Page
