Blackweb Sound Charge - Set the Alarm Timer; Set the Sleep Timer

Important:
- If no button is pressed for 15 seconds, the settings will be lost and you will need to start again.
• To display the clock time
- When you press the button, the clock time is displayed. Wait for a few seconds until the display returns to
the original display.
Set the Alarm Timer
You can set two alarms that go off at different times.
- Ensure that you have set the clock correctly.
1. Press and hold the or buttons on remote control in standby mode for a few seconds and the hour
digits will ash.
2. Press the buttons on the remote control to set the required hour. Then press the or buttons to
conrm the hour.
3. Press the buttons on the remote control to set the required minute. Then press the or buttons to
conrm the minute.
4. Press the buttons on the remote control to select an alarm sound source: FM tuner or buzzer.
Then press the or buttons to conrm.
5. Press the buttons on the remote control to select the required volume, we recommend no less than 5 as a
minimum. Then press the or buttons to conrm.
• Activate and Deactivate the Alarm Timer:
Press the or buttons repeatedly to activate or deactivate the timer.
If the timer is activated, [ AL 1 ] or [ AL 2 ] is displayed.
If the timer is deactivated, the [ AL 1 ] or [ AL 2 ] will disappear from the display on the front of the unit.
• Repeat Alarm:
You can press to adjust the interval to repeat alarm. When the alarm rings, press the SNOOZE button on
remote control. The alarm repeats ringing 9 minutes later.
• Stop Alarm Ring:
When the alarm rings, press the corresponding or or button. The alarm stops, but the alarm
settings remain.
• View the Alarm Settings:
Press the or buttons to view the alarm settings.
Set the Sleep Timer
This unit can switch to standby automatically after a set period of time.
1. Press the button on remote control repeatedly to select a set period of time (in minutes).
90 60 30 15 00
7