8
• When the sleep timer is activated, the display will show [ Zz ] and the volume will gradually decrease before
the unit powers off.
2. Press the button on remote control repeatedly until [00] is displayed.
• When the sleep timer is deactivated, [ Zz ] disappears from the display.
Adjust Display Brightness
Press the DIMMER button on remote control repeatedly to select different levels of display brightness.
Adjust the Volume
During play, press the VOL+/- buttons on remote control or on main unit to increase/decrease the volume level.
If you wish to turn the sound off, press the button on the remote control. Press the button again or press
VOL +/– button on remote control or on main unit to resume normal listening.
AUX Operation
You can listen to an external audio device through this unit.
1. Ensure that the unit is connected to the TV or audio device.
2. Press the button on the main unit or the button on the remote control to select the AUX source.
3. Start to play on the audio player.
4. Press the VOL +/– button on remote control or on main unit to adjust the volume to your desired level.
Radio (FM) Operation
Auto Scan and Save Preset Station
1. Press the button on the main unit or the FM button on the remote control to select FM mode.
2. Press and hold the PROG button on the remote control for a few seconds to activate automatic programming.
All available stations are programmed in the order of waveband reception strength.
- The rst programmed radio station is played automatically.
3. Press the or buttons on the remote control to select a preset number that you want.
Tuning in a Station
Press and hold the buttons on the remote control, the frequency changes down or up automatically until
a station is found. Press the buttons on the remote control repeatedly until you nd the station you want.
To Next Page
Loading...
