EasyManua.ls Logo

Blade Inductrix FPV BL BNF Basic - Low Voltage Cutoff (LVC); LVC System Explanation

Blade Inductrix FPV BL BNF Basic
128 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
EN
Low Voltage Cuto (LVC)
Once the battery reaches 3V under load, the ESC will continuously lower
power supplied to the motor until complete shutdown occurs. This helps
prevent over-discharge of the Li-Po battery. Land immediately once the ESC
activates LVC. Continuing to y after LVC can damage the battery, cause a
crash or both. Crash damage and batteries damaged due to over-discharge
are not covered under warranty.
Repeatedly ying the aircraft until LVC activates will damage the ight battery.
Disconnect and remove the Li-Po battery from the aircraft after use to
prevent trickle discharge. During storage, make sure the battery charge does
not fall below 3V per cell.
Battery Level Indicator
When rst powered on, the quadcopter indicates the charge level of the ight
battery by lighting the center LED taillight briey.
Taillight Color Battery Charge Level
Green fully charged
Yellow partially charged
Red discharged, do not y
After the ight battery charge level is shown, the LED taillight indicates
the active ight mode or the alternate chosen color as described in the
Changing the Center LED Taillight Color section.

Table of Contents

Related product manuals