6
EN
SAFETY INSTRUCTIONS
W
a
r
n
i
n
g
:
Make sure the appliance is disconnected from the power
before replacing the lamp in order to avoid the risk of electric
shock. Change the lamp only when the appliance has cooled
down. To unscrew the view port and the light, use a rubber
glove, which will make disassembly easier.
W
a
r
n
i
n
g
:
Installation should only be performed by qualified installers
and technicians.
W
a
r
n
i
n
g
:
The electrical plug must remain accessible after installation.
It must be possible to disconnect the appliance from the
power supply, either using a plug or by fitting a switch on the
fixed wiring system in accordance with installation rules.
If the power cable is damaged, it must be replaced by a cable
or a special kit available from the manufacturer or its After-
Sales Service Department.
To Next Page
Loading...
Need help?
General
