EasyManuals Logo

Blaupunkt Canberra C31 User Manual

Blaupunkt Canberra C31
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
40
Repeating tracks
Press button 3 (RPT) =.
The current track is repeated. RPT ap-
pears in the display. When the end of
the track is reached and the tape is re-
winding, “RPT TRCK” appears in the
display.
To stop repeating the track,
press button 3 (RPT) = again.
Normal playback is then continued. RPT
disappears from the display.
Scanning all the tracks on a
cassette (SCAN)
Press the SCAN button 4.
“CAS SCAN” appears in the display. All
the tracks on the cassette are briefly
played in ascending order.
To stop scanning,
Press the SCAN button 4 again.
The current track will then continue to
be played.
Note:
You can set the scanning time. For
further details, read the section en-
titled “Setting the scantime” in the
“Radio mode” chapter.
In order for the S-CPS, RPT and
SCAN functions to work properly,
there must be a pause of at least
three seconds between each track
on the cassette.
Pausing playback (PAUSE)
To pause the cassette whilst it is play-
ing,
press button 2 ( ) =.
Playback is paused and “PAUSE” ap-
pears in the display.
Press button 2 ( ) = again to
cancel pause.
Switching radiomonitor on/off
Note:
You can switch the radiomonitor on/
off whilst a cassette is playing.
Press the MENU button <.
Keep pressing the or button
; until “RM ON” or “RM OFF” ap-
pears in the display.
Press the or button ; to
switch the radiomonitor on/off.
When you have finished making your
changes,
press the MENU button <.
Skipping blank spaces
(blankskip)
You can automatically skip blank spac-
es on the tape that are longer than ten
seconds. To do so, the “blankskip” fea-
ture must be activated.
Note:
You can switch “blankskip” on/off
whilst a cassette is playing.
CASSETTE MODE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Blaupunkt Canberra C31 and is the answer not in the manual?

Blaupunkt Canberra C31 Specifications

Amplifier IconAmplifier
output power sine4 x 25 watts
output power max4 x 45 watts
voltage14.4 V
Tuner IconTuner
FM frequency range87.5 - 108 MHz
MW frequency range531 - 1, 602 kHz
LW frequency range153 - 279 kHz
Frequency Response IconFrequency Response
FM frequency response35 - 16, 000 Hz
cassette frequency response30 - 18, 000 Hz
Inputs and Outputs IconInputs and Outputs
pre-amp out channels4 channels
pre-amp out voltage3 V
AUX input sensitivity2 V / 6 kΩ
Tel./Navi input sensitivity10 V / 1 kΩ

Related product manuals