Blaupunkt Canberra C31 User Manual

30
Switching on by inserting a cassette
If the unit is switched off and there is no
cassette inserted in the drive,
➮ Gently insert the cassette with the
open side facing towards the right
into the drive until you feel some
resistance.
The cassette will be drawn automatically
into the drive.
You must not hinder or assist the drive
as it draws in the cassette.
The unit switches on. Cassette playback
begins.
Switching on/off
There are various ways of switching the
unit on/off:
Switching on/off using the vehicle
ignition
If the unit is correctly connected to the
vehicle's ignition and it was not switched
off using button @, it will switch on/off
simultaneously with the ignition.
You can also switch the unit on even if
the ignition is off:
➮ To do so, press button @.
Note:
● To protect the vehicle battery, the
unit will switch off automatically af-
ter one hour if the ignition is off.
Switching on/off using the
removable control panel
➮ Remove the control panel.
The unit switches off.
➮ Attach the control panel again.
The unit switches on. The settings (ra-
dio, cassette, CD changer or AUX) that
were set before the unit was switched
off will be reactivated.
Switching on/off using button @
➮ To switch the unit on, press button
@.
➮ To switch the unit off, press button
@ for longer than two seconds.
The unit switches off.
SWITCHING ON/OFF

Blaupunkt Canberra C31 Specifications

Amplifier

output power sine	4 x 25 watts
output power max	4 x 45 watts
voltage	14.4 V

Tuner

FM frequency range	87.5 - 108 MHz
MW frequency range	531 - 1, 602 kHz
LW frequency range	153 - 279 kHz

Frequency Response

FM frequency response	35 - 16, 000 Hz
cassette frequency response	30 - 18, 000 Hz

Inputs and Outputs

pre-amp out channels	4 channels
pre-amp out voltage	3 V
AUX input sensitivity	2 V / 6 kΩ
Tel./Navi input sensitivity	10 V / 1 kΩ