Changing basic settings in the settings menu
110
for passengers in the front
and rear – at the head level
in the center of the vehicle.
Ensure that all passengers in
the vehicle are sitting and re-
maining quiet.
Change to the "DEQ" menu
and call up one of the user-de-
fi ned equalizer settings ("EQ-1"
to "EQ-3") as described in the
preceding section.
Open the "USER EQ ADJUST"
menu as described on page
109.
Press the softkey
7 (next to
"AUTO") and follow the instruc-
tions on the display.
After a 5-second countdown,
you hear the test noise and
the main line
A intermittently
shows "SILENCE PLEASE" and
"ADJUSTING".
The automatic equalizer setting
fi nishes successfully if "AD-
JUSTMENT OK" appears on the
main line
A. The equalizer set-
ting is saved. Any previously
stored setting under this equal-
izer setting is overwritten. The
new setting can now be called
up under the corresponding
equalizer setting ("EQ-1" to
"EQ-3").
•
➔
➔
➔
➔
MANUAL:
As an alternative, you can manual-
ly create the equalizer setting
without measurement microphone.
In each of the six frequency bands,
you can select one specifi c indi-
vidual centre frequency and fi nely
adjust its level and quality factor Q.
Insert a CD with which you are
very familiar.
Adjust bass, treble, balance,
and fader to zero.
Open the "USER EQ ADJUST"
menu as described on page
109.
Press the softkey
< (next to
"MANUAL").
First, select a frequency band
to be changed. First, change
the centre, then the treble, fol-
lowed by the bass.
"LOW1" to "2": To change the
bass (20 to 250 Hz).
"HIGH1" to "4": To change
the centre or treble (320 to
20,000 Hz).
The frequency spectrum is dis-
played. if you already changed
the level in another frequen-
cy band, this change is visible
in the frequency spectrum. The
current centre frequency (Hz)
is highlighted.
➔
➔
➔
➔
➔
•
•
03_BA_Casablanca_1_ENG.indd Menü11003_BA_Casablanca_1_ENG.indd Menü110 31.05.2006 11:15:52 Uhr31.05.2006 11:15:52 Uhr
To Next Page
Loading...
