Blaupunkt CASABLANCA MP56 - Creating;Changing a User-Defi Ned Equalizer Setting (ADJUST)

Changing basic settings in the settings menu
109
ENGLISH DEUTSCHFRANÇAISITALIANO
NEDERLANDS
Creating/changing a user-defi ned equalizer setting ( ADJUST)
You can adjust the three different user-defi ned equalizer settings to
different situations, e.g. for the driver alone, for driver and passenger
or for passengers in the front and the rear.
Select the user-defi ned equalizer setting which you want to create/
change as described in the preceding section.
Press the softkey < (next to "ADJUST"). The "USER EQ ADJUST"
menu opens.
ADJUST
USER EQ-1 ADJUST
MANUAL
DEQMAXEX
AUTO
PLACE MICRO 5
BREAK
80 Hz +11db Q1
LOW1
LOW2
HIGH1
HIGH2
HIGH3
HIGH4
➔
➔
AUTO :
You can automatically create one
of the three equalizer settings us-
ing a measurement microphone
(available as an accessory).
Before starting, ensure the fol-
lowing:
The measurement microphone
must be connected before in-
stalling the device as described
in the installation instructions
of the measurement micro-
phone.
There must be true silence dur-
ing the measurement since ex-
ternal noise falsify the meas-
urement. For this reason, close
all windows, doors, and the
sliding sunroof.
•
•
Switch off the engine, but
leave the ignition switched on.
The temperature inside the ve-
hicle must be below 55 °C.
All the loudspeakers must be
connected. The sound radi-
ating from the loudspeakers
must not be obstructed by any
objects.
Position the measurement mi-
crophone
for the driver only – 10 cm
next to the right ear of the
driver,
for driver and passenger –
exactly between both at the
head level,
•
•
➔
•
•
03_BA_Casablanca_1_ENG.indd Menü10903_BA_Casablanca_1_ENG.indd Menü109 31.05.2006 11:15:52 Uhr31.05.2006 11:15:52 Uhr