4
SECTION 1 – IMPORTANT SAFEGUARDS
Read all instructions carefully before using your Rapid Rinser�
1.1 HEALTH CERTIFICATION
The Blendtec Rapid Rinser and its accessories are certified by NSF International
(NSF), under Blendtec�
1.2 WATER HOSE PRECAUTIONS
▶
Do not operate with a damaged water hose or fitting�
▶
Should the water line or fitting become damaged, it should be replaced by a qualified
person to avoid hazard�
▶
Do not allow the water line to hang over the edge of the work surface�
▶
Always shut the water off at the source before cleaning, moving, or servicing�
1.3 TURN OFF THE WATER WHEN NOT IN USE
1.4 NEVER OPERATE THIS DEVICE WITHOUT A BLENDER JAR (OR
OTHER DRINK CONTAINER) IN PLACE
▶
Avoid contacting the spray nozzle while the system is pressurized�
▶
Never use the unit if it is not secured to the work surface with the suction cups provided
or used in the Rapid Rinse Station�
▶
Do not rinse cracked or broken glassware with this device�
1.5 NEVER OPERATE THE UNIT IF IT APPEARS TO BE DAMAGED
If the unit malfunctions, call Blendtec first� If it is dropped or damaged in any way, call
Blendtec Technical Support at 1�800�Blendtec (1�800�253�6383) to evaluate the extent of
damage and the possibility of either repair or replacement�
1.6 INSTALL UNIT WITH APPROPRIATE BACKFLOW PROTECTION
Backflow prevention must be installed to comply with federal, state or local codes that have
jurisdiction over the location�
1.7 DO NOT USE WATER THAT IS HOTTER THAN 120°F (48°C) IN THE
RAPID RINSER
To Next Page
Loading...
