7
5.5 ONCE THE SPRAY OF WATER HAS SUBSIDED, REMOVE THE
RINSED BLENDER JAR AND ALLOW IT TO DRY IN THE INVERTED
POSITION
5.6 TURN THE WATER OFF WHEN THE RAPID RINSER IS NOT IN USE.
THIS WILL PREVENT ANY POSSIBILITY OF SPRAY WHEN A BLENDER
JAR IS NOT IN POSITION
SECTION 6 - SANITATION�
6.1 SHORT-TERM SANITATION
Shut off the water� Disconnect the water hose from the water source� Carefully pull the
Rapid Rinser away from the sink basin floor� Immerse the entire Rapid Rinser in a sink full of
sanitizing solution per the sanitizer’s manufacturer’s recommendation� Pull the Rapid Rinser
out of the sanitizing solution and rinse it completely with clean water� Allow the unit to dry�
Re-attach the water fitting to the water source�
6.2 LONG-TERM SANITATION
Shut off the water� Disconnect the water hose from the water source� Carefully pull the Rapid
Rinser away from the sink basin floor� Unscrew the spray nozzle from the bottom shell�
Carefully separate the two halves of the Rapid Rinser� DO NOT misplace the spring inside
the unit (see Figure 2)� Always clean and sanitize the unit as per the requirements of your
governing health department�
Thoroughly rinse the Rapid Rinser and all of its components after sanitation� Set the Rapid
Rinser and all of its components aside and allow them to dry completely� Reassemble the
Rapid Rinser by carefully placing the spring on top of the female threaded portion of the
water valve (Figure 2)� Place the top shell of the Rapid Rinser over the spring such that the
opening aligns with the spring� Insert the spray nozzle into the opening and thread until tight�
Replace the Rapid Rinser in the sink basin and reattach the water hose to the water source�
SECTION 7 - WARRANTY AND SERVICE
7.1 THE BLENDTEC RAPID RINSER IS WARRANTIED FOR A PERIOD
OF ONE YEAR FROM THE DATE OF PURCHASE / RECEIPT AGAINST
MANUFACTURING AND MATERIAL DEFECTS. THE STAINLESS STEEL
SPRAY NOZZLE HAS A LIFETIME WARRANTY
7.2 NOTE: OBVIOUS ABUSE OR MISTREATMENT OF THE RAPID RINSER
MAY VOID THE WARRANTY
7.3 SHOULD YOU NEED SERVICE, PLEASE CONTACT YOUR BLENDTEC
REPRESENTATIVE
To Next Page
Loading...
