Blodgett DFG-100 Service Manual (English)

Other manuals for Blodgett DFG-100

Installation Operating & Maintenance Manual49 pages

Replacement Parts List32 pages

Specifications2 pages

Questions and Answers:

H
heatherrobertsJul 30, 2025
What to do if my Blodgett DFG-100 will not fire?
- M
  Matthew MillerJul 30, 2025
  If your Blodgett Convection Oven won't fire, there are several potential causes: * The gas supply might be off. In this case, turn the gas valve to the ON position. * The oven may not be properly connected to a power source. Ensure the electrical supply cord is plugged in. * The power switch on the control panel could be off. Set the control panel to COOK or OVEN ON. * The control might be set below the ambient temperature. Adjust the control to the desired cooking temperature. * The doors might be open. Make sure the doors are fully closed.
S
Susan GonzalezAug 9, 2025
Why is the convection fan not running in my Blodgett DFG-100?
- T
  travisadamsAug 10, 2025
  If the convection fan in your Blodgett Convection Oven isn't running, consider these possibilities: 1. The oven might not be plugged in. Ensure the electrical supply cord is properly connected. 2. The oven may not be set to the cook mode. Set the control panel to COOK or OVEN ON. 3. A circuit breaker may have tripped. Try resetting the breaker. 4. The fan delay feature might be activated (if applicable). Deactivate the fan delay feature. 5. The doors could be open. Close the doors completely.
T
Timothy LuceroAug 19, 2025
What to do if my Blodgett Convection Oven does not come to ready?
- A
  Angelica CarterSep 12, 2025
  If your Blodgett Convection Oven isn't reaching the ready state, here are some things to check: * The oven may not have reached the preheat temperature yet. Allow sufficient time for preheating. * The gas valve might not be fully open. Check the gas valve and turn it on completely if needed. * The quick disconnect could be disconnected. Reconnect the quick connect and inspect all gas connections. * The gas pressure to the oven might be too low. Contact your local gas representative to check the pressure. * The fan delay feature may be activated, if applicable. Deactivate fan delay feature.

Blodgett DFG-100 Specifications

General

Model	DFG-100
Type	Convection Oven
Pan Size	18" x 26"
Construction	Stainless Steel
Temperature Range	200°F to 500°F
Control Type	Digital
Convection System	Dual-speed fan