Blomberg BGRP34520CSS - 2 Installation; Appliance Placement and Floor Support; Room Ventilation Requirements for Installation; Installation and Connection Compliance

To ensure that critical air gaps are maintained
under the appliance, we recommend that this
appliance is mounted on a solid base and that
the feet do not sink into any carpet or soft floor-
ing.
The kitchen floor must be able to carry the
weight of the appliance plus the additional weight
of cookware and bake ware and food.
• If an appliance hood is to befitted, refer to
the manufacturer's instructions regarding
fixing height.
• The appliance corresponds to device class 1,
i.e. it may be placed with the rear and one
side to kitchen walls, kitchen furniture or
equipment of any size. The kitchen furniture
or equipment on the other side may only be
of the same size or smaller.
• Any kitchen furniture next to the appliance
must be heat-resistant (212 oF min.).
Room ventilation
The air for combustion is taken from the room air
and the exhaust gases are emitted directly into
the room.
Good room ventilation is essential for safe opera-
tion of your appliance. If there is no window or
door available for room ventilation, an extra
ventilation must be installed.
Do not install this appliance in a room below
ground level unless it is open to ground lev~l on
at least one side. Failure to install correctly IS
dangerous and could result in prosecution.
Prolonged intensive use of the appliance may call
for additional ventilation, for example the opening
of a window, or the use of permanent fixed
mechanical ventilation system, for example, an
extractor fan or cooker hood that ventilates to the
outside.
14/EN
Be sure your appliance is properly installed and
grounded by a qualified technician in accordance
with the National Fuel Gas Code ANSI Z223.-
latest edition, or in Canada, CAN/CGA 8149.1,
and CAN/CGA 8149.2, and National Electrical
Code ANSI/NFPA No. 70- latest edition, or in
Canada GSA Standard C22.1, Canadian Electrical
Code, Part 1 and local code requirements.
Installation and connection
e IMPORTANT:
1 Do not install the appliance next to refrigera-
1--•ors or freezers. The heat emitted by the
appliance will lead to an increased energy
consumption of cooling appliances.
• For installation the appliance must be con-
nected in accordance with all local electrical
and/or as re ulations.
AUTION:
nit is heavy and requires a least two persons
r proper equipment to move.
• Hidden surfaces may have sharp edges.
Use caution when reaching behind or under
appliance.
• Do not use the oven or warming drawer (if
equipped) for storage.