Blue Clean AR112 - Garden Hose Adapter Installation; OPERATING INSTRUCTIONS

9
OPERATING INSTRUCTIONS
 
detergent or cleaner with a water ratio according to instructions on
the container (Fig. 7). The detergent bottle comes with a straw which

the bottle and attach it to the screw-on top (Fig. 8).
Note: the ratio of water to detergent is 10:1 or 10 parts water to 1 part
detergent.
Garden Hose Adapter
 
is made up of two separate pieces. (1) A clear plastic adapter with

attachment (Fig. 9).
 First, remove the plastic shipping cover on the water inlet on the back
of the power washer. Attach the clear plastic adapter by screwing it

blue/black collar attachment to your garden hose (Fig. 11). Slide the
blue/black collar onto the clear adapter, it will “click” into place. The
water is now connected to your power washer.
 To remove the water hose, simply pull back on the blue collar and
it will slide off the clear adapter. Note: this can be done at any time.
Water will not come out of the garden hose as the blue/black collar

when it is connected to the clear adapter.
You have now completed the assembly of your BLUE CLEAN POWER
WASHER and are now ready to begin using your electric power washer.
Read and observe all safety instructions.
Garden
Hose
Adapter
Pump
Hose
QC-Clear
Adapter
QC - Clear
Adapter
Garden Hose
Adapter (GHA)
On
O
Fig. 7
Fig. 9
Fig. 10
Fig. 8
Fig. 11
Fig. 12
Fig 7
Reset
Fig. 13
 Turn on the water supply at the faucet.
 Make sure the “ON/OFF” switch is in the “OFF” position. The power
switch has international symbols for ‘on’ and ‘off’: On (--) Off (O), (Fig.
12).
 Unwind the power cord completely and plug the GFCI into a
grounded 120 volt outlet. Press the ‘reset’ button on the GFCI box
(Fig.13 ). The indicator window should show a red color. This must be
done each time the unit is plugged in.
 Release the safety lock button on the spray gun by pressing the
safety lock button from right to left. While pointing the spray gun in
a safe direction, squeeze the trigger on the spray gun until there is a
steady stream of water, letting the water and air out of the hose.
 Press the ‘ON’ button. The motor and pump should now be running
and providing a powerful spray.