24
FILLING THE POOL WITH WATER
• Before lling the pool with water, thoroughly check to see if there are any loose screws not
tightened during the pool frame installation process. Also, check for holes or tears in the liner.
• Fill the pool until the water is halfway up the skimmer opening or a minimum of 6-in (15-cm) from
the top of the pool wall (see diagram 36). This will ensure water is entering the skimmer opening
and owing into the lter system.
SAFETY WARNING! To avoid pool collapse, never leave the pool empty without water!
The warranty does not cover damage to an empty pool.
Make sure pool waterline is
6-in (15-cm) below the top
of the pool wall.
(Diagram 36)
To Next Page
Loading...
