App Settings
© BlueFire LLC ↑ Go to the top Version 3.3 | Page 21
Note, setting or changing a Night Mode option (Light Sensor, Set Times, Manual On)
requires you to go back to the Home page to activate the change.
LED Brightness: This allows you to set the level of brightness by a percentage. 100%
down to 1% (Note: please remember that the LED colors are there for a reason so it is not
possible to turn them off completely.)
TPMS: This configures your axle/tire configuration for a TPMS installation (see the TPMS
section below). Set the number of tires per axle and whether the axle is a trailer (towed)
axle. After enabling TPMS, a TPMS icon will appear on the Home page that will show the
status of your tires. You have to restart the App before the TPMS icon will show. A TPMS
Text gauge is also available for your custom dash.
Fuel Tanks: This is where you specify the Fuel Tank Type (single, dual or different) and
the primary Fuel Tank Capacity. If your fuel level gauge is not accurate you can also select
the Show Calculated Fuel Level Gauge option. This option will calculate your fuel level and
fuel remaining based on fuel used from the engine computer, the Fuel Tank Capacity
entered above and tapping the Fuel Fill Up button on the Trip page or your custom dash.
Custom Colors: This will show the Custom Colors page which allows you to customize any
of the colors used by the App. To customize the colors of your dash and gauges use the
Custom Colors options in the Customize Dash and Customize Gauges pages.
Audio Alert: Changes the audio alert and volume used by reconnection alerts and your
custom gauges alerts. You can choose any valid ringtone or audio file on your mobile
device. Note that for Windows devices the volume is associated with the device's system
volume. For example if the system volume is at 50% and you choose an alert volume of
50%, your actual alert volume will be 25% of the device's highest volume level.
Dealer Search Order: This allows you to change the order of dealers when searching for
a dealer in the Faults page. Note, in Demo mode you can only select one dealer. Once you
connect to the adapter you can select more.
Odometer Offset: Set this if your vehicle dash odometer is different from your custom
dash odometer and you want to make them the same. For example, if the vehicle shows
100,000 but the App shows 100,010 set the offset to -10 so the App will show 100,000.
Speedometer Offset: Set this if your vehicle dash speedometer is different from your
custom dash speedometer and you want to make them the same. This is most likely caused
with oversized tires. Note, this is a ratio that you have to calculate based on your tire size.
Fuel Used Offset: If you need to adjust fuel used for any reason, you can input a positive
or negative number to help obtain a more accurate reading.
Engine Hours Offset: The engine hours displayed on your instrument panel may be
different from the app reading coming from the engine itself. This is not uncommon when
To Next Page
Loading...