BlueParrott B350-XT Quick Start Guide

VXi BlueParrott
®
B350-XT
™
Quick-Start Guide
Wearing and Adjusting the B350-XT
To get the best performance from our noise-canceling technology, position the microphone near the corner of your mouth.
Positioning is important; small adjustments in microphone placement can improve performance.
1) Place the headset on your head.
2) Position the speaker directly on your ear. You can slide the headband in or
out of the side support for proper fit.
3) Position the microphone about one finger’s width away from your face at the corner of your mouth.
4) The headband can be adjusted by gently flexing it outward to loosen or inward to tighten.
Charging
Connect charger cord to the headset’s charging port. The headset LED will glow red when charging and blue when fully
charged.
Turning Headset On/Off
Turn Headset On: Hold down the MFB for approximately 2-3 seconds, until you hear a voice prompt,
“Power On.” The blue light will flash twice every second.
Turn Headset Off: Hold down the MFB for approximately 3-4 seconds, until you hear a voice prompt,
“Power Off.” A red light will flash 4 times and the headset will turn off.
One-Touch Pairing (NFC)
1) Make sure that NFC is enabled on your cell phone.
2) Place the NFC zone of your cell phone against the NFC zone of the
headset and hold together until your cell phone confirms pairing is successful.
Note: NFC and One-Touch Pairing are dependent on your cell phone. The size
and sensitivity of your phone’s NFC zone and the specific way to connect the
headset may vary between devices.
Manual Pairing
Placing Headset into Pairing Mode: With the headset powered off, press and hold the MFB. You will hear the voice prompt
“Power On”. Keep holding the MFB for approximately 10 seconds, until you hear “Discovering”. Indicator lights will
alternately flash between red and blue. Headset will be visible for pairing to devices for 120 seconds.
Pairing to a Cell Phone:
1) Make sure that other Bluetooth devices are turned off or out of range.
2) Place headset into pairing mode.
3) Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer’s instructions.
4) Select “VXi B350-XT” to pair. (Passcode is “0000” if needed.)
5) When connected, the headset will give you the voice prompt, “Your headset is connected”.
Multi-Point Mode
In multi-point mode, the headset can be simultaneously paired and connected to two cell phones. The headset will
automatically switch between phones when there is an incoming call.
To use Multi-Point:
1) Pair each device you wish to use with the headset. Power off the headset.
2) Enable Bluetooth, or power on both paired devices, then power on the headset.
3) You should hear the voice prompt “Your headset is connected” twice, as the headset connects to each device.
Parrott Button
The Parrott Button provides an easy way to mute the headset. In the future, it will also be programmable for other functions.
Check back at www.vxicorp.com for updates and more information.
IMPORTANT: CHARGE HEADSET FULLY PRIOR TO FIRST USE
IMPORTANT SAFETY NOTE: Prolonged exposure to high volume levels can damage your hearing. To avoid injury, set the
volume to the lowest comfortable level. If you experience ringing in your ears, or voices sound muffled, stop using the
headset. Avoid turning up the volume to block noisy surroundings. Your ears may adapt to volume that is too high,
which could result in permanent hearing damage without any noticeable discomfort.
1. B350-XT™ Headset
2. Spare Foam Ear Cushion
3. Spare Microphone Windscreen
4. USB Charging Cable
5. Auto Adapter
6. AC/DC Wall Charger
7. Quick-Start Guide
Features and Functions
A. Flexible Microphone Boom
B. Volume Down
C. Volume Up/Mute
D. Multifunction Button (MFB)
E. Indicator Lights
F. Parrott Button
Package Contents
Function
Power On
Power Off
Enable Pairing Mode
Volume Up
Volume Down
Mute (On/Off)
Answer a Call/Active Call
End a Call
Transfer Audio
Low Battery
Button/Duration of Press
MFB (2-3 seconds)
MFB (3-4 seconds)
MFB (5-15 seconds)
Volume Up (quick press)
Volume Down (quick press)
Parrott Button (quick press)
MFB (quick press)
MFB (quick press)
Volume Down (1-2 seconds)
n/a
LED Indicator
Blue, double flash (1 second)
All LEDs turn off
Alternating red and blue flash
NONE
NONE
NONE
Blue flash, once per second
Blue flash, every 4 seconds
NONE
Red flash
Audio Indicator
Short tone
NONE
NONE
Single tone
Single tone
Single tone, reminder
tone every 10 seconds
Two rising tones
Two falling tones
NONE
NONE
Voice Indicator
“Power on”
“Power off”
“Discovering”
NONE
NONE
NONE
NONE
NONE
NONE
“Battery low”
Quick-Reference Tables
Multiple Device Pairing and Advanced Features
The VXi BlueParrott B350-XT can pair with up to eight (8) devices. However, only two (2) devices may be connected to the
headset at one time (Multi-Point). For more information on advanced features, please refer to the complete user guide,
available online.
For the full user guide, technical notes, and available accessories, go to www.vxicorp.com.
Function
Power On
Power Off
Enable Pairing Mode
Volume Up
Volume Down
Mute (On/Off)
Answer a Call/Active Call
End a Call
Transfer Audio
Low Battery
Button/Duration of Press
MFB (2-3 seconds)
MFB (3-4 seconds)
MFB (5-15 seconds)
Volume Up (quick press)
Volume Down (quick press)
Parrott Button (quick press)
MFB (quick press)
MFB (quick press)
Volume Down (1-2 seconds)
n/a
LED Indicator
Blue, double flash (1 second)
All LEDs turn off
Alternating red and blue flash
NONE
NONE
NONE
Blue flash, once per second
Blue flash, every 4 seconds
NONE
Red flash
Audio Indicator
Short tone
NONE
NONE
Single tone
Single tone
Single tone, reminder
tone every 10 seconds
Two rising tones
Two falling tones
NONE
NONE
Voice Indicator
“Power on”
“Power off”
“Discovering”
NONE
NONE
NONE
NONE
NONE
NONE
“Battery low”
Multiple Device Pairing and Advanced Features
The VXi BlueParrott B350-XT can pair with up to eight (8) devices. However, only two (2) devices may be connected to the
headset at one time (Multi-Point). For more information on advanced features, please refer to the complete user guide,
available online.
For the full user guide, technical notes, and available accessories, go to www.vxicorp.com.
271 Locust Street | Dover, NH 03820
Toll Free: 800-742-8588
| Phone: 603-742-2888 | www.vxicorp.com
© 2014 VXi Corporation. All rights reserved. APN 203478X6 04/14
E
A
D
B
F
C
E
A
D
B
F
C
VXi BlueParrott
®
B350-XT
™
Quick-Start Guide
Wearing and Adjusting the B350-XT
To get the best performance from our noise-canceling technology, position the microphone near the corner of your mouth.
Positioning is important; small adjustments in microphone placement can improve performance.
1) Place the headset on your head.
2) Position the speaker directly on your ear. You can slide the headband in or
out of the side support for proper fit.
3) Position the microphone about one finger’s width away from your face at the corner of your mouth.
4) The headband can be adjusted by gently flexing it outward to loosen or inward to tighten.
Charging
Connect charger cord to the headset’s charging port. The headset LED will glow red when charging and blue when fully
charged.
Turning Headset On/Off
Turn Headset On: Hold down the MFB for approximately 2-3 seconds, until you hear a voice prompt,
“Power On.” The blue light will flash twice every second.
Turn Headset Off: Hold down the MFB for approximately 3-4 seconds, until you hear a voice prompt,
“Power Off.” A red light will flash 4 times and the headset will turn off.
One-Touch Pairing (NFC)
1) Make sure that NFC is enabled on your cell phone.
2) Place the NFC zone of your cell phone against the NFC zone of the
headset and hold together until your cell phone confirms pairing is successful.
Note: NFC and One-Touch Pairing are dependent on your cell phone. The size
and sensitivity of your phone’s NFC zone and the specific way to connect the
headset may vary between devices.
Manual Pairing
Placing Headset into Pairing Mode: With the headset powered off, press and hold the MFB. You will hear the voice prompt
“Power On”. Keep holding the MFB for approximately 10 seconds, until you hear “Discovering”. Indicator lights will
alternately flash between red and blue. Headset will be visible for pairing to devices for 120 seconds.
Pairing to a Cell Phone:
1) Make sure that other Bluetooth devices are turned off or out of range.
2) Place headset into pairing mode.
3) Put your cell phone in Bluetooth Search/Scan Mode per the manufacturer’s instructions.
4) Select “VXi B350-XT” to pair. (Passcode is “0000” if needed.)
5) When connected, the headset will give you the voice prompt, “Your headset is connected”.
Multi-Point Mode
In multi-point mode, the headset can be simultaneously paired and connected to two cell phones. The headset will
automatically switch between phones when there is an incoming call.
To use Multi-Point:
1) Pair each device you wish to use with the headset. Power off the headset.
2) Enable Bluetooth, or power on both paired devices, then power on the headset.
3) You should hear the voice prompt “Your headset is connected” twice, as the headset connects to each device.
Parrott Button
The Parrott Button provides an easy way to mute the headset. In the future, it will also be programmable for other functions.
Check back at www.vxicorp.com for updates and more information.
IMPORTANT SAFETY NOTE: Prolonged exposure to high volume levels can damage your hearing. To avoid injury, set the
volume to the lowest comfortable level. If you experience ringing in your ears, or voices sound muffled, stop using the
headset. Avoid turning up the volume to block noisy surroundings. Your ears may adapt to volume that is too high,
which could result in permanent hearing damage without any noticeable discomfort.
1. B350-XT™ Headset
2. Spare Foam Ear Cushion
3. Spare Microphone Windscreen
4. USB Charging Cable
5. Auto Adapter
6. AC/DC Wall Charger
7. Quick-Start Guide
Features and Functions
A. Flexible Microphone Boom
B. Volume Down
C. Volume Up/Mute
D. Multifunction Button (MFB)
E. Indicator Lights
F. Parrott Button
Package Contents
NFC Zone
IMPORTANT: CHARGE HEADSET FULLY PRIOR TO FIRST USE
Quick-Reference Tables
271 Locust Street | Dover, NH 03820
Toll Free: 800-742-8588
| Phone: 603-742-2888 | www.vxicorp.com
© 2014 VXi Corporation. All rights reserved. APN 203478X6 04/14

BlueParrott B350-XT Specifications

General

Impedance	32 Ω
Driver unit	36 mm
Ear coupling	Supraaural
Headphone frequency	20 - 20000 Hz
Headphone sensitivity	123 dB
Microphone mute	Yes
Microphone type	Boom
Microphone frequency	100 - 10000 Hz
Microphone sensitivity	-47 dB
Microphone direction type	Bidirectional microphone
Cables included	USB
Battery type	Built-in battery
Standby time	500 h
Battery capacity	300 mAh
Battery recharge time	3 h
Headset type	Monaural
Product type	Headset
Certification	CE, C-Tick, FCC, IC, TELEC, WEEE
Product color	Black
Wearing style	Head-band
Volume control	Buttons
Country of origin	China
Recommended usage	Office/Call center
International Protection (IP) code	IP54
Storage temperature (T-T)	-10 - 45 °C
Operating temperature (T-T)	-10 - 60 °C
USB connector	Micro-USB
Wireless range	100 m
3.5 mm connector	No
Bluetooth version	5.0
Bluetooth profiles	A2DP, HFP, HSP
Connectivity technology	Wired
Frame material	Rubber, Stainless steel
USB cable length	1 m
Microphone cartridge	6 mm
Mobile operating systems supported	Android, iOS
Master (outer) case width	400 mm
Master (outer) case height	206 mm
Master (outer) case length	290 mm
Master (outer) case weight	3540 g
Harmonized System (HS) code	85183000
Quantity per master (outer) case	16 pc(s)
Package depth	75 mm
Package width	172 mm
Package height	175 mm
Package weight	300 g

Weight and Dimensions

Depth	140 mm
Width	165 mm
Height	50 mm
Weight	247 g