VXi BlueParrott
®
Point
TM
User Guide PAGE 13
GETTING STARTED (continued)
Making/Taking Calls
The headset must be on and connected with your phone.
Making a Call
1. Dial the desired number on your phone. You will hear the call in the headset.
2. To end the call, press the MFB once. The call will end and the headset will enter standby mode.
Answering a Call
1. When you receive a call, you will hear ring tones in the headset. Press the MFB once to answer the call.
2. To end the call, press the MFB once. The call will end and the headset will enter standby mode.
Rejecting an Incoming Call
1. To reject an incoming call, press and hold the MFB for two seconds. You will hear a two-note
descending tone and the call will be transferred to your voicemail (if available).
VXi BlueParrott
®
Point
TM
User Guide PAGE 14
ADVANCED FEATURES AND FUNCTIONS
Multiple Device Pairing and Multipoint Mode
The Point has pairing memory for up to 8 devices. The headset can also use Multipoint Mode, which
means that it can be connected to two Bluetooth devices at the same time. You do not have to do
anything to enable Multipoint Mode.
Using the Point in Multipoint Mode
1. To use the headset in Multipoint Mode, first make sure the headset is paired with both your devices.
2. With both devices in range and with their Bluetooth enabled, turn the headset on.
3. As each Bluetooth device connects to the headset, you will hear the voice prompt, “Your headset
is connected.”
The Point will monitor both phones and enable you to answer a call on either one from the headset.
If you are on a call and the other device receives a call, you will hear a notification in the headset.
To Next Page
Loading...
