3.4.5 Connect the AC Cable
Please refer to Step 2 in Section 3.4.1 of the A80P Microinverter User Manual for details.
3.4.6 Connect the PV Modules
Join the MC4 connectors together to establish the connection between the PV modules
and the D100P. You'll hear a click when they're in place.
The arrow in the figure below illustrates the connection.
• Do not expose the BLUETTI Battery to direct sunlight.
• Ensure that there is approximately 1.8 inches (45 mm) of clearance between the floor
and the BLUETTI Battery rack, as shown in the figure below. Please consider the possibil-
ity of water accumulation on rainy days.
Hint
Microinverter
PV Controller
The picture is a schematic
diagram of the B210 battery pack
EN
JUST POWER ON
16
To Next Page
Loading...