11
© Bluewater Group 2016
INSTALLATION
Install Cleone in accordance with local regulations. If you are not sure,
contact a Bluewater dealer for aid. Bluewater has no responsibility for
installation of Cleone.
If the Cleone is connected to a public water supply, the system shall be
protected against backflow.
Before installation
Remove the cable ties under Cleone before it is installed. They are used for load securing of
the pump.
Figure 11. Remove cable ties
Install clean water faucet
Measure the clean water faucet for measure A.
Figure 12.
2
3 4
5
1
Ø 13 mm
(1/2”)
A
A
1234567
Install clean water faucet
To Next Page
Loading...
