08
Complete User manual
Clean water faucet
Figure 7.
0
1
Clean water faucet
Pos Description
0 Clean water faucet in closed position
1 Clean water faucet in open position
Water filtration system
Cleone cleans water in three steps: prefiltration, membrane filtration and postfiltration. Clean water from Cleone is collected in the
clean water tank. When the tank is full, Cleone is put in standby mode. When the clean water tank level is low, Cleone opens the
feed water supply and starts to clean water.
Water connections
There are four water connectors on the connection side of Cleone. The collet rings and tubing have a color code.
Color Connection Description
ORANGE Feed water The feed water connection supplies feed water to Cleone.
RED Drain water Drain water from Cleone to the drain pipe contains flushed and rejected
contamination.
YELLOW Clean water tank Clean water is collected in the clean water tank before it is supplied to the clean
water faucet.
BLUE Clean water faucet Clean water from Cleone to the clean water faucet.
Intelligent membrane flush
The reverse osmosis membrane is flushed regularly with water in standby mode. The membrane is also flushed before and after
the cleaning cycle. This makes sure that the cleaning process always starts with fresh feed water.
Water quality system
The cleaning process is continuously monitored to make sure that the water quality is high. If the water quality decreases, the
system operation indicator flashes. If the problem continues, Cleone stops.
To Next Page
Loading...
